How Much Water Should You Put In Your Bong?
Here's how to eyeball it to fill your bong with water . . .
1- Downstem slits should all be underwater. If you don't have any fancy percolators - you can stop here! Usually about an inch or so of water. You can fill these through the mouthpiece or the hole where the downstem sits.
Click here if you have no clue what a downstem is.
2- If you have 1 perc: that perc should be underwater with all it's holes covered.
Click here to find out what perc bongs are all about.
3- If you have 2 percs: cover both percs with water so that all the slits and holes are submerged. Fill from the mouthpiece, not the joint. Water should trickle down from the top perc (if not - blow into it or tilt the bong a bit until it covers the lower perc).
The Balancing Act: The trick is to submerge all the slits that air will flow through so it gets filtered through the water before you inhale. But if you're tasting bongwater as it splashes your lips -- you're filling the water too high or pulling too hard. Every cool bong is an art, take the time to get to know yours!
Cannabis or weed is as old as it gets. The origins of smoking cannabis date back to ancient civilizations in Central and South Asia. The plant has been cultivated for...
Weren’t the good old days precious when we used to hide in the basement and smoke weed? In those times, finding a decent flower was very difficult and we could...
Kief, also known as dry sift or pollen, is a concentrated mass of trichomes that have been separated from the cannabis plant. It is typically collected by sifting the trichomes...